Single 40 DCOE GENUINE WEBER Carburettor Conversion Kit Nissan Datsun A14 A15
This setup is designed to upgrade your A14/A15 motor without having to maintain a second carburettor yet still allowing a broad area of tune-ability and performance. All parts are brand new, hand prepared here in our workshop on the Sunshine Coast in Queensland.
Carburettor is a new 40 DCOE Weber that is Spanish Made. This is a genuine Weber that are still being produced today. Manifold is made by Rowland Manifolds and are a good quality casting promoting high flow and efficiency. This will still suit Water Port heads that have water flowing through the manifold. It will just block the water ports but your cooling system will still flow. Overhead linkages are included and are produced by Redline Australia.
Base gaskets for the carburettor are included. If you require a manifold to head gasket, please call us to add to your order.
Ramtubes are included in the sale however if you require an air filter, please call us to discuss your options of air filters and required space to make sure your setup will clear the wheel arch.
These model DCOE's are a must if you are looking to get the best performance out of any engine. The benefits of fitting DCOE's are their fine tuning capabilities. With DCOE's, you can alter the following:
- - Choke Venturis
- - Booster Venturis
- - Main Jets
- - Air Jets
- - Emulsion Tubes
- - Idle Jets
- - Idle Emulsion
- - Pump Jet
- - Cold Start Jet
- - Needle Valve Size
- - Idle Air Bleeds
A multitude of tuning areas that you just cannot do easily with most other brands of carburettors.
Know that you're buying a genuine Carburettor. See in our gallery for the photo that outlines where to tell if the carburettor is Genuine or not.
We Hand Prepare these carburettors, making sure that the following are set:
- - Float levels to Weber Standard
- - Throttle Butterflies are aligned and moving freely
- - Mixture screws are set to a standard stetting
- - Idle Speed screw is set to a standard setting
- - Idle Air Bleed screws are set to zero
These are done so that we know you are getting a product that is more likely to bolt on and run for you without any hassle.
The kit comes with ram tubes included. If you prefer an air filter, please select from options above.
Redline linkage kit uses HEX rod (no slip) and all metal parts (no plastic)
- - New Spanish Weber 40 DCOE Carburettor
- - New Rowland Single Sidedraft Manifold
- - Ramtubes
- - New Overhead Linkage Kit
PLEASE BE AWARE ALL CARBURETTORS REQUIRE PREPARATION AND/OR ASSEMBLY, THIS WILL TAKE 2-4 DAYS
CONTACT US FOR MORE EXPRESS SHIPPING OPTIONS!