Chrysler Valiant Hemi - GENUINE WEBER Triple 40 DCOE Side Carburettor Full Setup
Classic and still very popular. This is a brand new set.
This set is all brand new supplied complete with:
- - Triple 40 DCOE Spanish Weber Carburettors
- - New Redline manifold suit HEMI 6 CYLINDER Motors
- - Overhead Hex-Rod Linkage set
- - Ramtubes (Air filters option available)
All mounting hardware and ram tubes are included. Each carburetor is hand prepared to your order. The DCOE sidedraft is designed for sports / race / rally style driving, well suited to modified motors and all motorsport.
The carburettors are all thoroughly checked over before sending. The carbs are not pre-jetted however, baseline jetting can be arranged at an extra cost.
The linkage kit utilizes a hex rod linkage bar, meaning no slippage and a more consistent balance and tune. We supply you all the linkage components to allow you to mount your factory Throttle cable on, a return spring etc. You will need to make a throttle cable bracket or we can supply one at an extra cost. (see installed photo for reference)
We supply you with the appropriate fuel inlets so that you do not need a fuel block to split into 3. We also hard mount the carburettors onto the manifold to help with future maintenance with Balancing and Tuning. If you prefer soft mounts, please contact us to arrange this. We supply you with the needed studs, nuts, gaskets etc to bolt carbs onto the manifold.
IF YOU HAVE AN AUTOMATIC TRANSMISSION:
YOU MUST CALL SELECT AUTOMATIC TRANSMISSION OPTION ABOVE TO GET YOUR GEARBOX TO WORK WITH THIS SET! YOUR GEARBOX GENERALLY IS A VALVE BODY SETUP AND NEEDS TO REGISTER 0-100% THROTTLE POSITION, OTHERWISE GEARBOX DAMAGE MAY OCCUR. WE SUPPLY THE COMPONENTS AT NO EXTRA COST.
You also have the option of swapping the Ramtubes for Air Filters. Triple carb setups gives your engine the ultimate opportunity of making full horsepower without any means of forced induction. Not only will you get to hear a sweet induction noise, your engine will accelerate at a quicker rate making it perfect for Sports/ Motorsports driving.
Most Valiants have the Heater Blower Motor protruding out into the engine bay. Sometimes this may come into contact with the carburettor setup. There are blanking plates available if yours does not fit. Please call us if you have any concerns and we can advise from there.
The Webers have standard factory jetting, we can pre-jet this set with the E38 / E49 jetting - please call us to discuss this option.